R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Command Reference

91
Table 21 Command output
Field Descri
p
tion
Vlan-interface2 current state
Physical state of a VLAN-interface:
• DOWN (Administratively)—The administrative state of the
VLAN-interface is down, because it has been shut down with the
shutdown command.
• DOWN—The administrative sate of the VLAN-interface is up, but its
physical sate is down. The VLAN corresponding to this interface
does not contain any physical port in the UP state (possibly because
the ports are not well connected or the lines have failed).
• UP—Both the administrative state and the physical state of the
VLAN-interface are up.
Line protocol current state
Link layer protocol state of a VLAN-interface:
• DOWN—The protocol state of the VLAN-interface is down.
• UP—The protocol state of the VLAN-interface is up.
Description Description string of a VLAN-interface.
The Maximum Transmit Unit MTU of a VLAN-interface.
Internet protocol processing :
disabled
The interface is not capable of processing IP packets. This information
is displayed when the interface is not configured with an IP address.
Internet Address is
192.168.1.54/24 Primary
The primary IP address of the interface is 192.168.1.54/24. This
information is displayed only if the primary IP address is configured for
the interface.
Internet Address is 6.4.4.4/24 Sub
The secondary IP address of the interface is 6.4.4.4/24. This
information is displayed only if a secondary IP address is configured
for the interface.
IP Packet Frame Type IPv4 outgoing frame format.
Output queue Output queue type.
Hardware address MAC address corresponding to a VLAN-interface.
IPv6 Packet Frame Type IPv6 outgoing frame format.
Last clearing of counters
Time when the reset counters interface vlan-interface command was
last used to clear the interface statistics.
Never indicates the reset counters interface vlan-interface command
has never been used on the interface after the device's startup.
The brief information of interface(s)
under route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Link layer state of an interface:
• ADM—The interface has been administratively shut down. To
recover its physical state, use the undo shutdown command.
• Stby—The interface is operating as a standby interface. To see the
main interface, use the display standby state command.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP, but its
link is an on-demand link or not present at all, its protocol attribute
includes the spoofing flag (an s in parentheses).
Interface Abbreviated interface name.