R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Configuration Guide

[RouterA] display link-aggregation summary

Aggregation Interface Type:

BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation

Aggregation Mode: S -- Static, D -- Dynamic

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing

Actor System ID: 0x8000, 000f-e2ff-0001

AGG AGG Partner ID Select Unselect Share

Interface Mode Ports Ports Type

-------------------------------------------------------------------------------

RAGG1 S none 3 0 Shar

The output shows that link aggregation group 1 is a load-sharing-capable Layer 3 static

aggregation group that contains three Selected ports.

# Display the global link-aggregation load-sharing criteria on Router A.

[RouterA] display link-aggregation load-sharing mode

Link-Aggregation Load-Sharing Mode:

destination-ip address, source-ip address

The output shows that the global link-aggregation load-sharing criteria are the source and

destination IP addresses of packets.

Layer 3 dynamic aggregation configuration example

Network requirements

Configure a Layer 3 dynamic aggregation group on Router A and Router B (in Figure 10) and configure

IP addresses and subnet masks for the Layer 3 aggregate interfaces.

Enable traffic to be load-shared across aggregation group member ports based on source and

destination IP addresses.

Figure 10 Network diagram

Configuration procedure

1. Configure Router A:

# Create Layer 3 aggregate interface Route-Aggregation 1, configure the link aggregation mode

as dynamic, and configure an IP address and subnet mask for the aggregate interface.

<RouterA> system-view

[RouterA] interface route-aggregation 1

[RouterA-Route-Aggregation1] link-aggregation mode dynamic

[RouterA-Route-Aggregation1] ip address 192.168.1.1 24

[RouterA-Route-Aggregation1] quit