R3102-R3103-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

99
HDLC configuration commands
default
Use default to restore the default settings for an interface.
Syntax
default
Views
HDLC interface view
Default command level
2: System level
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you execute it on a live network.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies or system restrictions. Use the display this command in interface view to identify these
commands, and then use their undo forms or follow the command reference to individually restore their
default settings. If your restoration attempt still fails, follow the error message instructions to resolve the
problem.
Examples
# Restore the default settings of interface Serial 3/1/1.
<Sysname> system-view
[Sysname] interface Serial3/1/1
[Sysname-Serial3/1/1] default
This command will restore the default settings. Continue? [Y/N]:y
link-protocol hdlc
Use link-protocol hdlc to enable HDLC encapsulation on an interface.
Syntax
link-protocol hdlc
Default
PPP encapsulation is configured on an interface.
Views
Interface view