R3102-R3103-HP 6600/HSR6600 Routers Layer 3 - IP Routing Configuration Guide

229
Step Command Remarks
3. Configure the interval for
sending the same update to a
peer or peer group.
peer { group-name | ip-address }
route-update-interval interval
Optional.
By default, the intervals for sending
the same update to an IBGP peer
and an EBGP peer are 15 seconds
and 30 seconds, respectively.
If the interval is set to 0, the same
update is sent to a BGP peer
immediately when a route is
changed.
Enabling the BGP ORF capability
The BGP Outbound Route Filtering (ORF) feature allows a BGP speaker to send its BGP peer a set of ORFs
through route-refresh messages. The peer then applies the ORFs—in addition to its local routing policies
(if any)—to filter updates to the BGP speaker, reducing the number of exchanged Update messages and
saving network resources.
After you enable the BGP ORF capability, the local BGP router negotiates the ORF capability with the
BGP peer through Open messages (determines whether to carry ORF information in messages, and if yes,
whether to carry non-standard ORF information in the packets). After completing the negotiation process
and establishing the BGP session, the BGP router and its BGP peer can exchange ORF information
through specific route-refresh messages.
For the parameters configured on both sides for ORF capability negotiation, see Table 7.
T
o enable the BGP ORF capability:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ipv4-family vpn-instance
vpn-instance-name
Use either method.
3. Enable BGP route refresh for a
peer or peer group.
peer { group-name | ip-address }
capability-advertise route-refresh
Enabled by default.
4. Enable the non-standard ORF
capability for a BGP peer or
peer group.
peer { group-name | ip-address }
capability-advertise orf
non-standard
Optional.
By default, standard BGP ORF
capability defined in RFC 5291
and RFC 5292 is supported.
If the peer supports only
non-standard ORF, you need to
configure this command.
5. Enable the ORF capability for
a BGP peer or peer group.
peer { group-name | ip-address }
capability-advertise orf ip-prefix
{ both | receive | send }
Disabled by default.