R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

148
Syntax
mpls te igp shortcut [ isis | ospf ]
undo mpls te igp shortcut
Default
An IGP does not consider MPLS TE tunnels in its enhanced SPF calculation.
Views
Tunnel interface view
Default command level
2: System level
Parameters
isis: Sets the IGP protocol to IS-IS.
ospf: Sets the IGP protocol to OSPF.
Usage guidelines
The mpls te igp shortcut command cannot be used together with the mpls te igp advertise command.
Examples
# Enable OSPF and IS-IS to consider TE tunnel 0 (in up state) in its enhanced SPF calculation.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te igp shortcut
mpls te link administrative group
Use mpls te link administrative group to configure the link administrative group attribute.
Use undo mpls te link administrative group to restore the default.
Syntax
mpls te link administrative group value
undo mpls te link administrative group
Default
The link administrative group attribute is 0x00000000.
Views
Interface view
Default command level
2: System level
Parameters
value: Link administrative group attribute, in the range of 0x00000000 to 0xFFFFFFFF. It is a set of 32
link properties. Each bit represents a property with a value of 0 or 1. By ANDing the administrative group
attribute bits with the corresponding link affinity attribute bits of an MPLS TE tunnel, MPLS TE identifies the
properties of the links that the MPLS TE tunnel can use.