R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

158
Examples
# Adopt the FF reservation style when setting up the CR-LSP tunnel for TE tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te resv-style ff
mpls te retry
Use mpls te retry to configure the maximum number of tunnel setup retries.
Use undo mpls te retry to restore the default.
Syntax
mpls te retry times
undo mpls te retry
Default
The maximum number of tunnel setup retries is 10.
Views
Tunnel interface view
Default command level
2: System level
Parameters
times: Number of tunnel setup retries, in the range of 10 to 4294967295.
Usage guidelines
You can configure the system to attempt setting up a tunnel multiple times until it is established
successfully or until the number of attempts reaches the upper limit.
Examples
# Set the maximum number of tunnel setup retries to 20.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te retry 20
Related commands
mpls te timer retry
mpls te route-pinning
Use mpls te route-pinning to enable route pinning.
Use undo mpls te route-pinning to restore the default.
Syntax
mpls te route-pinning
undo mpls te route-pinning