R3102-R3103-HP 6600/HSR6600 Routers MPLS Command Reference Guide

163
mpls te timer retry
Use mpls te timer retry to configure the interval for re-establishing the tunnel.
Use undo mpls te timer retry to restore the default.
Syntax
mpls te timer retry seconds
undo mpls te timer retry
Default
The interval for re-establishing a tunnel is 2 seconds.
Views
Tunnel interface view
Default command level
2: System level
Parameters
seconds: Interval for re-establishing the tunnel, in the range of 1 to 4294967295 seconds.
Examples
# Set the interval for re-establishing tunnel 0 to 20 seconds.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te timer retry 20
Related commands
mpls te retry
mpls te tunnel-id
Use mpls te tunnel-id to configure the tunnel ID.
Syntax
mpls te tunnel-id tunnel-id
Views
Tunnel interface view
Default command level
2: System level
Parameters
tunnel-id: Specifies a tunnel ID. For the value range, see the matrix table in the Usage guidelines.
The following matrix shows the value ranges for the tunnel-id argument: