R3102-R3103-HP 6600/HSR6600 Routers Network Management and Monitoring Command Reference

67
Default
The NQA server is disabled.
Views
System view
Default command level
2: System level
Examples
# Enable the NQA server.
<Sysname> system-view
[Sysname] nqa server enable
Related commands
• nqa server tcp-connect
• nqa server udp-echo
• display nqa server status
nqa server tcp-connect
Use nqa server tcp-connect to configure a listening service to enable the NQA server to listen and
respond on the specified IP address and port.
Use undo nqa server tcp-connect to remove the TCP listening service.
Syntax
nqa server tcp-connect ip-address port-number
undo nqa server tcp-connect ip-address port-number
Views
System view
Default command level
2: System level
Parameters
ip-address: Specifies the IP address for the TCP connect listening service.
port-number: Specifies the port number for the TCP connect listening service, in the range of 1 to 50000.
Usage guidelines
Configure the command on the NQA server for the TCP operation only.
The IP address and port number must be consistent with those on the NQA client and must be different
from those of an existing TCP listening service.
The IP address must be that of an interface on the NQA server. Otherwise, the configuration is invalid.
Examples
# Configure a TCP listening service to enable the NQA server to listen and respond on the IP address
169.254.10.2 and port 9000.
<Sysname> system-view