R3303-HP 6600/HSR6600 Routers High Availability Configuration Guide

226
Task Command Remarks
Display information about the
specified or all track entries.
display track { track-entry-number | all } [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Track configuration examples
VRRP-Track -NQA collaboration configuration example
In this example, the master monitors the uplink.
Network requirements
As shown in Figure 60, configure Host A to access Host B on the Internet. The default gateway of Host
A i s 10 .1.1.10 / 2 4 .
Router A and Router B belong to VRRP group 1, which has the virtual IP address 10.1.1.10.
When Router A works correctly, packets from Host A to Host B are forwarded through Router A. When
NQA detects that a fault is on the uplink of Router A, packets from Host A to Host B are forwarded
through Router B.
Figure 60 Network diagram
Configuration procedure
1. Configure the IP address of each interface as shown in Figure 60. (Details not shown.)
2. Configure an NQA test group on Router A:
# Create an NQA test group with the administrator name admin and the operation tag test.
<RouterA> system-view
[RouterA] nqa entry admin test
# Configure the test type as ICMP echo test.
[RouterA-nqa-admin-test] type icmp-echo
# Configure the destination address as 10.1.2.2.
[RouterA-nqa-admin-test-icmp-echo] destination ip 10.1.2.2