R3303-HP 6600/HSR6600 Routers Interface Configuration Guide

41
Configuring a CE3 interface in CE3 mode
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CE3 interface view.
controller e3 interface-number N/A
3. Configure the interface to
operate in CE3 mode.
using ce3
Optional.
The default operating mode is CE3
mode.
4. Set the operating mode of an
E1 line on the CE3 interface to
unframed mode or framed
mode.
• Set the operating mode to
unframed (E1) mode:
e1 line-number unframed
• Set the operating mode to
framed (CE1) mode and
bundle timeslots on the CE1
interface:
a. (Optional) undo e1
line-number unframed
b. e1 line-number
channel-set set-number
timeslot-list list
By default, E1 lines are operating
in framed mode, but no channel
sets exist.
5. Set other interface
parameters.
See "Configuring other CE3
interface parameters."
Optional.
Configure PPP, FR, and IP address for the CE3 interface if the network requires.
Configuring other CE3 interface parameters
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter CE3 interface view.
controller e3 interface-number N/A
3. Configure the interface
description.
description text
Optional.
By default, the description
of an interface is
interface-name Interface.
4. Set the physical state change
suppression interval on the CE
3 interface.
link-delay delay-time
By default, physical state
change suppression is
disabled.
5. Configure the CE3 interface
to perform BERT test, and
configure the CE3 interface to
perform BERT test on an E1
channel created on the
interface.
bert pattern { 2^7 | 2^11 | 2^15 | qrss }
time number [ unframed ]
e1 line-number bert pattern { 2^11 | 2^15
| 2^20 | 2^23 | qrss } time number
[ unframed ]
Optional.
By default, no BERT test is
performed.