R3303-HP 6600/HSR6600 Routers IP Multicast Configuration Guide

302
Figure 85 Network diagram
Configuration procedure
1. Enable IPv6 forwarding on each router and assign an IPv6 address and prefix length to each
interface according to Figure 85. (Details not shown.)
2. Conf
igure OSPFv3 on the routers to make sure they are interoperable at the network layer and
they can dynamically update their routing information. (Details not shown.)
3. Enable the IPv6 multicast routing, and enable IPv6 PIM-DM and MLD:
# Enable IPv6 multicast routing on Router A, enable IPv6 PIM-DM on each interface, and enable
MLD on the host-side interface GigabitEthernet 2/1/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] mld enable
[RouterA-GigabitEthernet2/1/1] pim ipv6 dm
[RouterA-GigabitEthernet2/1/1] quit
[RouterA] interface pos 5/1/0
[RouterA-Pos5/1/0] pim ipv6 dm
[RouterA-Pos5/1/0] quit
# Enable IPv6 multicast routing on Router B, enable IPv6 PIM-DM on each interface, and enable
MLD on the host-side interface GigabitEthernet 2/1/1.
<RouterB> system-view
[RouterB] multicast ipv6 routing-enable
[RouterB] interface gigabitethernet 2/1/1
[RouterB-GigabitEthernet2/1/1] mld enable
[RouterB-GigabitEthernet2/1/1] pim ipv6 dm
[RouterB-GigabitEthernet2/1/1] quit
[RouterB] interface pos 5/1/0
[RouterB-Pos5/1/0] pim ipv6 dm
Router A
Router B
Router C
Querier
IPv6 PIM network
N1
N2
Receiver
Receiver
Host A
Host B
Host C
Host D
GE2/1/1
3000::12/64
GE2/1/1
3001::10/64
GE2/1/1
3001::12/64
POS5/1/0
POS5/1/0
POS5/1/0