R3303-HP 6600/HSR6600 Routers Layer 2 - LAN Switching Configuration Guide

27
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the global
link-aggregation
load-sharing criteria.
link-aggregation
load-sharing mode
{ { destination-ip |
destination-mac |
source-ip | source-mac } *
| per-packet }
The default settings are source and destination
MAC addresses for Layer 2 traffic and source
and destination IP addresses for Layer 3 traffic.
Global link-aggregation load sharing criteria
configuration applies to all aggregation groups.
Configuring load-sharing criteria for an aggregation group
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate interface
view:
interface route-aggregation
interface-number
Use either command.
3. Configure the load-sharing
criteria for the aggregation
group.
link-aggregation load-sharing mode
{ { destination-ip | destination-mac |
source-ip | source-mac } * |
per-packet }
The default setting is the global
load-sharing criteria.
Layer 2 aggregate interfaces do
not support the per-packet
keyword.
Enabling local-first load sharing for link aggregation
To enable local-first load sharing for link aggregation:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enable local-first load-sharing
for link aggregation.
link-aggregation load-sharing
mode local-first
Optional.
By default, the function is enabled.
Displaying and maintaining Ethernet link
aggregation