R3303-HP 6600/HSR6600 Routers Layer 2 - WAN Command Reference Guide

28
pvp limit
Use pvp limit to set the parameters for VP policing.
Use undo pvp limit to delete the VP policing.
Syntax
pvp limit vpi output-scr
undo pvp limit vpi
Default
VP policing is not performed.
Views
ATM interface view
Default command level
2: System level
Parameters
vpi: Specifies the VPI of the ATM network, in the range of 0 to 255.
output-scr: Specifies the sustainable rate of ATM cell output (in kbps). For more information about the
value range, see Table 10.
Usage guidelines
When applying VP policing, the parameters of PVC are still valid. Only when the parameters of PVC and
VP policing are satisfied, will the packets be transmitted and received. In calculating the traffic, the
LLC/SNAP, MUX and NLPID headers are included, but the ATM cell header is not included.
Examples
# Set the traffic of VP with vpi 1 to 2000 Kbps.
<Sysname> system-view
[Sysname] interface atm 1/0/1
[Sysname-Atm1/0/1] pvp limit 1 2000
Related commands
• pvc
• service cbr
• service vbr-nrt
• service vbr-rt
• service ubr
remark atm-clp
Use remark atm-clp to configure the action of setting the CLP bit for ATM cells for the traffic behavior.
Use undo remark atm-clp to cancel the action.
Syntax
remark [ green | red | yellow ] atm-clp atm-clp-value