R3303-HP 6600/HSR6600 Routers Layer 3 - IP Routing Command Reference

207
Views
IS-IS view
Default command level
2: System level
Parameters
seconds: Specifies the LSP maximum aging time in seconds, in the range of 1 to 65535.
Examples
# Set the maximum LSP age to 1500 seconds.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] timer lsp-max-age 1500
Related commands
timer lsp-refresh
timer lsp-refresh
Use timer lsp-refresh to configure the LSP refresh interval.
Use undo timer lsp-refresh to restore the default.
Syntax
timer lsp-refresh seconds
undo timer lsp-refresh
Default
The default LSP refresh interval is 900 seconds.
Views
IS-IS view
Default command level
2: System level
Parameters
seconds: Specifies the LSP refresh interval in seconds, in the range of 1 to 65534.
Usage guidelines
To refresh LSPs before they are aged out, the interval configured by the timer lsp-refresh command must
be smaller than that configured by the timer lsp-max-age command.
Examples
# Configure the LSP refresh interval as 1500 seconds.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] timer lsp-refresh 1500
Related commands
timer lsp-max-age