R3303-HP 6600/HSR6600 Routers Layer 3 - IP Routing Configuration Guide

337

Configuring OSPFv3 route redistribution

Network requirements

• As shown in Figure 99, Router A, Router B, and Router C are in Area 2.

• OSPFv3 process 1 and OSPFv3 process 2 are enabled on Router B. Router B communicates with

Router A and Router C through OSPFv3 process 1 and OSPFv3 process 2, respectively.

• Configure OSPFv3 process 2 to redistribute direct routes and the routes from OSPFv3 process 1 on

Router B, and set the default metric for redistributed routes to 3. Router C can then learn the routes

destined for 1::0/64 and 2::0/64, and Router A cannot learn the routes destined for 3::0/64 or

4::0/64.

Figure 99 Network diagram

Configuration procedure

1. Configure IPv6 addresses for interfaces. (Details not shown.)

2. Configure OSPFv3 basic functions:

# Enable OSPFv3 process 1 on Router A.

<RouterA> system-view

[RouterA] ipv6

[RouterA] ospfv3 1

[RouterA-ospfv3-1] router-id 1.1.1.1

[RouterA-ospfv3-1] quit

[RouterA] interface GigabitEthernet 2/1/2

[RouterA-GigabitEthernet2/1/2] ospfv3 1 area 2

[RouterA-GigabitEthernet2/1/2] quit

[RouterA] interface GigabitEthernet 2/1/1

[RouterA-GigabitEthernet2/1/1] ospfv3 1 area 2

[RouterA-GigabitEthernet2/1/1] quit

# Enable OSPFv3 process 1 and OSPFv3 process 2 on Router B.

<RouterB> system-view

[RouterB] ipv6

[RouterB] ospfv3 1

[RouterB-ospfv3-1] router-id 2.2.2.2

[RouterB-ospfv3-1] quit

[RouterB] interface GigabitEthernet 2/1/2

[RouterB-GigabitEthernet2/1/2] ospfv3 1 area 2

[RouterB-GigabitEthernet2/1/2] quit

[RouterB] ospfv3 2