R3303-HP 6600/HSR6600 Routers MPLS Command Reference Guide

228
Use undo xconnect peer to delete the VCs for a service instance.
Syntax
xconnect peer peer-ip-address pw-id pw-id [ access-mode { ethernet | vlan } | mtu mtu-value |
[ pw-class class-name ] [ backup-peer ip-address backup-pw-id pw-id [ backup-pw-class class-name |
revertive [ wtr-time wtr-time ] ] * ] ] *
undo xconnect peer
Views
Service instance view
Default command level
2: System level
Parameters
peer-ip-address: Specifies the IP address of the remote peer.
pw-id pw-id: Specifies the PW ID of the Martini VC. The value range for the PW ID is 1 to 4294967295.
access-mode: Specifies the access mode of the service instance as Ethernet or VLAN. The default access
mode is VLAN.
ethernet: Specifies the access mode as Ethernet.
vlan: Specifies the access mode as VLAN.
mtu mtu-value: Specifies the MTU in the range of 46 to 65535. The default is 1500.
pw-class class-name: Specifies a PW class by its name, a case-insensitive string of 1 to 19 characters. If
you do not specify a PW class, or you specify a PW class but the PW class does not specify a tunneling
policy or the specified tunneling policy is not configured, the default tunneling policy will be used. The
default tunneling policy selects only one tunnel in this order: LSP tunnel, GRE tunnel, CR-LSP tunnel. For
information about how to configure a tunneling policy, see MPLS Configuration Guide.
backup-peer ip-address: Specifies the IP address of the peer PE of the backup VC.
backup-pw-id pw-id: Specifies the PW ID of the backup VC, in the range of 1 to 4294967295.
backup-pw-class class-name: Specifies the PW class for the backup VC. The class-name argument is a
case-insensitive string of 1 to 19 characters. If you do not specify a template class, or you specify a PW
class but the PW class does not specify a tunneling policy or the specified tunneling policy is not
configured, the default tunneling policy will be used. The default tunneling policy selects only one tunnel
in this order: LSP tunnel, GRE tunnel, CR-LSP tunnel. For information about how to configure a tunneling
policy, see MPLS Configuration Guide.
revertive: Enables support for switchback. With this keyword specified, when the primary VC recovers,
traffic is switched from the backup VC back to the primary VC automatically. If you do not specify this
keyword, traffic will not be switched back automatically.
wtr-time wtr-time: Specifies the switchback delay time. When the primary VC recovers, the device waits
for the switchback delay time before switching the traffic from the backup VC back to the primary VC. T
The value range for the wtr-time argument is 1 to 720 minutes, and the default is 30 minutes.
Usage guidelines
This command is supported only on routers with SAP-4EXPs.
The access mode refers to how a PE treats the outer VLAN tag carried in packets received from a CE, and
how the PE sends packets to the CE. Two access modes are available: