R3303-HP 6600/HSR6600 Routers MPLS Configuration Guide

432
adjacencies are in Full state, and that the PE and ASBR PE in the same AS have learned the routes
to the loopback interfaces of each other and can ping each other.
2. Configure basic MPLS and enable MPLS LDP on each MPLS backbone to establish LDP LSPs:
# Configure basic MPLS on PE 1 and enable MPLS LDP for both PE 1 and the interface connected
to ASBR-PE 1.
<PE1> system-view
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls
[PE1-mpls] quit
[PE1] mpls ldp
[PE1-mpls-ldp] quit
[PE1] interface pos 5/1/1
[PE1-POS5/1/1] mpls
[PE1-POS5/1/1] mpls ldp
[PE1-POS5/1/1] quit
# Configure basic MPLS on ASBR-PE 1 and enable MPLS LDP for both ASBR-PE 1 and the interface
connected to PE 1.
<ASBR-PE1> system-view
[ASBR-PE1] mpls lsr-id 2.2.2.9
[ASBR-PE1] mpls
[ASBR-PE1-mpls] quit
[ASBR-PE1] mpls ldp
[ASBR-PE1-mpls-ldp] quit
[ASBR-PE1] interface pos 5/1/1
[ASBR-PE1-POS5/1/1] mpls
[ASBR-PE1-POS5/1/1] mpls ldp
[ASBR-PE1-POS5/1/1] quit
# Configure basic MPLS on ASBR-PE 2 and enable MPLS LDP for both ASBR-PE 2 and the interface
connected to PE 2.
<ASBR-PE2> system-view
[ASBR-PE2] mpls lsr-id 3.3.3.9
[ASBR-PE2] mpls
[ASBR-PE2-mpls] quit
[ASBR-PE2] mpls ldp
[ASBR-PE2-mpls-ldp] quit
[ASBR-PE2] interface pos 5/1/1
[ASBR-PE2-POS5/1/1] mpls
[ASBR-PE2-POS5/1/1] mpls ldp
[ASBR-PE2-POS5/1/1] quit
# Configure basic MPLS on PE 2 and enable MPLS LDP for both PE 2 and the interface connected
to ASBR-PE 2.
<PE2> system-view
[PE2] mpls lsr-id 4.4.4.9
[PE2] mpls
[PE2-mpls] quit
[PE2] mpls ldp
[PE2-mpls-ldp] quit
[PE2] interface pos 5/1/1