R3303-HP 6600/HSR6600 Routers OAA Configuration Guide

9
ACFP configuration task list
Task Remarks
Enabling the ACFP server on the device Required.
Configuring the ACFP client (the OAP module) Required.
Enabling the ACFP trap function on the device Optional.
Enabling the ACFP server on the device
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the ACFP server.
acfp server enable Disabled by default.
Configuring the ACFP client (the OAP module)
You can use a MIB browser on the ACFP client to configure ACFP collaboration policies and ACFP
collaboration rules. The configuration procedure depends on the software used on the ACFP client.
When you disable the ACSEI function or change the working mode for an internal interface (a virtual
interface connecting the ACFP server with the ACFP client), to avoid service interruption, perform the
operation first on the ACFP client and then on the ACFP server.
Enabling the ACFP trap function on the device
To make ACFP work, enable the device to send trap messages of the ACFP module.
After the trap function on the ACFP module is enabled, the ACFP module generates trap messages to
report important events. The levels of the ACFP trap messages are described in Table 1.
Table 1 ACFP trap message level
Tra
p
messa
g
e Level
Context ID type changed Notifications
ACFP client registration Notifications
ACFP client deregistration Notifications
ACSEI detects that ACFP client had no response Warnings
ACFP server does not support the working mode of the ACFP client Errors
Expiration period of ACFP collaboration policy changed Notifications
ACFP collaboration rules are created Informational
ACFP collaboration rules are removed Informational
ACFP collaboration rules failed Errors