R3303-HP 6600/HSR6600 Routers Security Configuration Guide

284
[RouterA] acl ipv6 number 3101
[RouterA-acl-adv-3101] rule permit ipv6 source 333::0 64 destination 555::0 64
[RouterA-acl-adv-3101] quit
# Configure a static route to Host B.
[RouterA] ipv6 route-static 555::0 64 222::1
# Create an IPsec transform set named tran1.
[RouterA] ipsec transform-set tran1
# Specify the encapsulation mode as tunnel.
[RouterA-ipsec-transform-set-tran1] encapsulation-mode tunnel
# Specify the security protocol as ESP.
[RouterA-ipsec-transform-set-tran1] transform esp
# Specify the algorithms for the IPsec transform set.
[RouterA-ipsec-transform-set-tran1] esp encryption-algorithm des
[RouterA-ipsec-transform-set-tran1] esp authentication-algorithm sha1
[RouterA-ipsec-transform-set-tran1] quit
# Configure the IKE peer.
[RouterA] ike peer peer
[RouterA-ike-peer-peer] pre-share-key abcde
[RouterA-ike-peer-peer] remote-address ipv6 222::1
[RouterA-ike-peer-peer] quit
# Create an IPsec policy that uses IKE for IPsec SA negotiation.
[RouterA] ipsec policy map1 10 isakmp
# Apply the IPsec transform set.
[RouterA-ipsec-policy-isakmp-map1-10] transform-set tran1
# Apply the ACL.
[RouterA-ipsec-policy-isakmp-map1-10] security acl ipv6 3101
# Apply the IKE peer.
[RouterA-ipsec-policy-isakmp-map1-10] ike-peer peer
[RouterA-ipsec-policy-isakmp-map1-10] quit
# Apply the IPsec policy group to the interface.
[RouterA] interface gigabitethernet 3/0/2
[RouterA-GigabitEthernet3/0/2] ipsec policy map1
2. Configure Router B:
# Assign IPv6 addresses to interfaces. (Details not shown.)
# Define an ACL to identify data flows from subnet 555::0/64 to subnet 333::0/64.
<RouterB> system-view
[RouterB] acl ipv6 number 3101
[RouterB-acl-adv-3101] rule permit ipv6 source 555::/64 destination 333::/64
[RouterB-acl-adv-3101] quit
# Configure a static route to Host A.
[RouterB] ipv6 route-static 333::0 64 111::1
# Create an IPsec transform set named tran1.
[RouterB] ipsec transform-set tran1
# Specify the encapsulation mode as tunnel.
[RouterB-ipsec-transform-set-tran1] encapsulation-mode tunnel