HP Comware 5 About the HP Comware 5 Debugging Guide Part number: 5998-4932
Legal and notice information © Copyright 2014 Hewlett-Packard Development Company, L.P. No part of this documentation may be reproduced or transmitted in any form or by any means without prior written consent of Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice.
About the HP Comware 5 debug manual The HP Comware 5 debug manual describes the debugging commands found in Comware 5. The manual is split into three volumes. IMPORTANT: • Using debug commands require HPN Technical Certification and can affect equipment performance. • Debug commands should only be used when troubleshooting during a scheduled outage.
Volume Content • Customizable IVR debugging commands • CWMP (TR-069) debugging commands • DCC debugging commands • DDoS protection debugging commands • Device management debugging commands • DHCP debugging commands • DHCPv6 debugging commands • Dial plan debugging commands • DLDP debugging commands • DLSw debugging commands • DNS debugging commands • DDNS debugging commands • DVPN debugging commands The following groups of debugging commands are found in Volume 2: Volume 2 • • • • • • • • • • • • • • • •
Volume Content • ISDN debugging commands • IS-IS debugging commands • L2TP debugging commands • L2VPN access to L3VPN or IP backbone debugging commands • LAPB and X.
Volume Content • Voice RADIUS debugging commands • RIP debugging commands • RIPng debugging commands • RMON debugging commands • RPR debugging commands • RRPP debugging commands • RSH debugging commands • Service loopback group debugging commands • Session management debugging commands • SIP debugging commands • Smart Link debugging commands • SNMP debugging commands • Spanning tree debugging commands • SSH debugging commands • SSL debugging commands • SSL VPN debugging commands • Stateful failover debuggi
