About the Comware V5 Debug Manual

About the HP Comware 5 debug manual
The HP Comware 5 debug manual describes the debugging commands found in Comware 5. The
manual is split into three volumes.
IMPORTANT:
•
Using debug commands require HPN Technical Certification and can affect equipment
performance.
• Debug commands should only be used when troubleshooting during a scheduled outage.
Volume
Content
Volume 1
The following groups of debugging commands are found in Volume 1:
• 802.1X debugging commands
• AAA debugging commands
• RADIUS debugging commands
• HWTACACS debugging commands
• LDAP debugging commands
• SC debugging commands
• Local server debugging commands
• RADIUS server debugging commands
• ACFP debugging commands
• ACSEI debugging commands
• Active and standby switchover debugging commands
• Adjacency table debugging commands
• Service flow redirection debugging commands
• AFT debugging commands
• ALG debugging commands
• ARP debugging commands
• ARP snooping debugging commands
• ARP fast-reply debugging commands
• ATM debugging commands
• Attack detection and protection debugging commands
• Basic IP routing debugging commands
• Basic MPLS debugging commands
• BFD debugging commands
• BGP debugging commands
• Bridging debugging commands
• Call services debugging commands
• Call-watch debugging commands
• CFD debugging commands
• Cluster management debugging commands
• Connection limit debugging commands
• Content filtering debugging commands
• COPS debugging commands