HSR6800 Router Series Interface Module Guide

• The interface module can be configured with the card-mode command to operate in OC-3/STM-1

POS or OC-12/STM-4 POS mode.

• The configuration of the operating mode can take effect only after you hot-plug the interface module

or reboot the device. It is recommended to remove and insert the module to bring the configuration

into effect.

• The configuration of the operating mode takes effect for all the interfaces on the interface module.

• The interface module supports multi-mode short haul (1310 nm), single-mode medium haul (1310

nm), single-mode long haul (1310 nm), and single-mode ultra-long haul (1550 nm) transceiver

modules.

NOTE:

The HIM-MSP2P/HIM-MSP4P is an optional interface module to be separately ordered if needed.

Front panels

Figure 11 Front panel of HIM-MSP2P

(1) Captive screw (2) Ejector lever

(3) SFP port carrier si

nal LED (LINK/ACT)

(4)

SFP port loopback/alarm LED (LP/AL)

(5) SFP port 1 (155 Mbps)

SFP port 0 (622 Mbps)

(6)

SFP port 0

(155 Mbps)