HSR6800 Router Series Interface Module Guide

Item S

ecification

Fiber type

9/125 μm

single-mode

9/125 μm

single-mode

9/125 μm

single-mode

9/125 μm

single-mode

Interface cable

Test optical power before choosing a transceiver module and optical fiber, because an optical fiber

connector might have transmitted for dozens of kilometers from a user fiber.

The HIM-RS2P supports the connection of Mate interfaces within the module. All Mate interfaces in a

module can be connected without external transceiver modules or fibers.

For the appearance and connection of a HIM-RS2P interface cable, see "Connecting an optical interface

ble."

HIM-TS8P

The HIM-TS8P provides 8 ports, each of which can be switched between a POS interface and an Ethernet

port. A POS interface transmits data at OC-3/STM-1 (155.52Mbps) or OC-12/STM-4 (622Mbps). An

Ethernet port transmits data at 1000 Mbps. The HIM-TS8P is half the height of a HIM, and occupies one

slot on a FIP.

To switch the interface type of a HIM-TS8P, use the port-type switch command.

To switch the POS interface speed of a HIM-TS8P, use the speed command in POS interface view.

For more information about the port-type switch and speed commands, see HP 6600/HSR6600 Routers

Interface Command Reference or HP HSR6800 Routers Command References.

Front panel

Figure 17 Front panel

(1) Captive screw

(2) SFP port

(3) Ejector lever (4) SFP port carrier signal LED (LINK/ACT)

LEDs

Table 24 LED description

LED Status

Descri

tion

SFP

GE-1000Base-

LINK/ACT

(Green)

Off No link is present.

On A 1000 Mbps link is present.

Flashing Data is being transmitted or received at 1000 Mbps.