HP 6600/HSR6600/HSR6800 Router Series Interface Module Guide

38
Interface specifications
Table 45 Interface specifications
Item S
p
ecification
Connector type SFP
Number of interfaces 24
Interface standards 802.3, 802.3u, and 802.3ab
Supported frame
format
• Ethernet_II
• Ethernet_SNAP
Optical
transmit
power
Type Short haul Medium haul Long haul Long haul Ultra-long haul
Min. –9.5 dBm –9 dBm –2 dBm –4 dBm –4 dBm
Max. 0 dBm –3 dBm 5 dBm 1 dBm 2 dBm
Receiving sensitivity –17 dBm –20 dBm –23 dBm –21 dBm –22 dBm
Central wavelength 850 nm 1310 nm 1310 nm 1550 nm 1550 nm
Fiber type
62.5/125 μm
multi-mode
fiber
9/125 μm
single-mode
fiber
9/125 μm
single-mode
fiber
9/125 μm
single-mode
fiber
9/125 μm
single-mode
fiber
Max. transmission
distance
0.55 km
(0.3418 miles)
10 km (6.21
miles)
40 km (24.86
miles)
40 km (24.86
miles)
70 km (43.50
miles)
Interface speed
• 1000 Mbps (recommended)
• Full duplex
The SAP-24GBP supports the following types of transceiver modules:
• 100 Mbps SFP transceiver modules
• 1000 Mbps SFP transceiver modules
• 100/1000 Mbps SFP transceiver modules
• 10/100/1000 Mbps SFP copper transceiver modules supporting fiber-to-copper conversion (The
SAP-24GBP supports 10/100/1000 Mbps auto-sensing if used together with a transceiver
module.)
The SAP-24GBP is optional to be separately ordered if needed.
Use transceiver modules provided by HP only. The device might be incompatible with other transceiver
modules.
Interface cable
• When working with SFP transceiver modules, the SAP-24GBP must use an optical fiber with LC-type
connectors.
• When working with transceiver modules supporting fiber-to-copper conversion, the SAP-24GBP
uses category-5 straight-through or crossover Ethernet cables when operating at 10/100 Mbps,
and uses category-6 cable (recommended) when operating at 1000 Mbps.
For the appearance and connection of a SAP-24GBP interface cable, see "Connecting an Ethernet
inter
face cable" or "Connecting an optical interface cable."