HSR6800 Router Series Interface Module Guide

Figure 33 Connecting the 8E1 splitter cable (1)

{ If the 75-ohm 8E1 splitter cable need be extended, you can connect the BNC connector of the

cable to the coaxial cable connector and connect the other end of the coaxial cable connector

to the peer device through a 75-ohm E1 trunk cable.

Figure 34 Connecting the 8E1 splitter cable (2)

3. Examine the LINK LED after connection.

{ If the LED is on, the optical fiber link is present.

{ If the LED is off, a fault has occurred on the link and the signal is out of synchronization. In this

case, examine the link.