HP Comware 5 Debug Manual Vol 1

Syntax
debugging bgp detail
undo debugging bgp detail
Default
Detailed debugging for BGP is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Enabling debugging might decrease system performance. Therefore, use this command only when
necessary. Disable debugging after the debugging operation is complete.
Table 98 describes output fields and messages for the debugging bgp detail command.
Table 98 Output from the debugging bgp detail command
Field
Description
BGP.xxx BGP instance name.
BGP can't get physical interface index for
destination:X.X.X.X
BGP cannot get the physical interface index for
destination X.X.X.X.
Fail to search Token for destination X.X.X.X Token search for destination X.X.X.X failed.
Allocate token failed. destination= X.X.X.X,LspmErr=X
Failed to allocate Token: destination X.X.X.X, LSP
error code X.
There are XX routes allocate token failed at this time
before
BGP failed to allocate Tokens for XX routes.
Recv UPDATE with following RD XXX BGP received an Update message with RD XXX.
Received New VPNv4 Route with Ext-Community
NULL.Ignoring Route
BGP received a new VPNv4 route with
Ext-Community as NULL and therefore ignored the
route.
Received VPNv4 Packet But No Such Route In Loc Rib
BGP received a VPNv4 packet, and there is no such a
route in the local routing table.
operation XX Label operation code.
Receive SMB UP backup requirement
BGP r
eceived a standby board startup event
requesting an active/standby switchover.
Receive routine backup requirement
BGP received a routine request for an active/standby
switchover.
Receive SMB down backup requirement
BGP r
eceived a standby board down event
requesting an active/standby switchover.
Examples
# Enable detailed debugging for BGP. When a BGP peer relationship is being established, output
similar to the following example is generated:
<Sysname> debugging bgp detail
184