HP Comware 5 Debug Manual Vol 1

Dial plan debugging commands
The output description tables in this document only contain fields and messages that require an
explanation.
debugging voice dpl
Use debugging voice dpl to enable dial plan debugging.
Use undo debugging voice dpl to disable dial plan debugging.
Syntax
debugging voice dpl { all | error | general }
undo debugging voice dpl { all | error | general }
Default
Dial plan debugging is disabled.
Views
User view
Default command level
2: System level
Parameters
all: Specifies all types of debugging for dial plan.
error: Specifies error debugging.
general: Specifies general debugging.
Usage guidelines
Table 200 describes output fields and messages for the debugging voice dpl error command.
Table 200 Output from the debugging voice dpl error command
Field
Description
DPL_INTF: [GetCallingNumByIfIndex] Get null calling
number By VpIfIndex!
The calling number corresponding to the interface
index was not found.
DPL_INTF: [DPL_GetCurrentEntityFromTab]The call
information table index is invalid!
The call information table index was invalid.
DPL_SUBST: [MultTabMainProc]No suitable substitute
rule found! The user number 01 have not been
substituted.
The user number 01 was not substituted because
there was no matching number substitution rule in the
global number substitution rule list.
DPL_SUBST: [SingleTabMainProc]No suitable
substitute rule found! The user number 01 has not been
substituted.
The user number 01 was not substituted because
there was no matching number substitution rule in the
number substitution rule list applied to the voice entity
or voice subscriber line.
DPL_SRCH: [GetEntity]Cannot find suitable entity! No voice entity was matched.
379