HP Comware 5 Debug Manual Vol 2

HDLC link bundling debugging commands
NOTE:
Support for this debugging command depends on your device model.
The HDLC link bundling module name is identified as "BNDL" in debugging messages.
debugging bundle
Use debugging bundle to enable debugging for an HDLC link bundle interface.
Use undo debugging bundle to disable debugging for an HDLC link bundle interface.
Syntax
debugging bundle { all | error | event | packet } hdlc-bundle [ bundle-id ]
undo debugging bundle { all | error | event | packet } hdlc-bundle [ bundle-id ]
Default
Debugging for an HDLC link bundle interface is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies all types of debugging.
error: Specifies error debugging.
event: Specifies event debugging.
packet: Specifies packet debugging.
bundle-id: Specifies an HDLC link bundle interface by its number. The value range of this argument varies
by device model.
Usage guidelines
If a bundle ID is not specified, this command displays the debugging information of all the HDLC link
bundle interfaces.
If a bundle ID is specified, this command displays the debugging information of the specified HDLC link
bundle interface.
Table 7 describes the output fields and messages for the debugging bundle error command.
98