HP Comware 5 Debug Manual Vol 2

<Sysname> debugging link-aggregation error
*Nov 2 15:51:21:15 2007 Sysname LAGG/7/LAGG_DEBUG:
ERROR.203.0-14788557: Send configuration change message of member port failed
// LAGG failed to send member port configuration change messages.
debugging link-aggregation event
Use debugging link-aggregation event to enable link aggregation event debugging.
Use undo debugging link-aggregation event to disable link aggregation event debugging.
Syntax
debugging link-aggregation event
undo debugging link-aggregation event
Default
Link aggregation event debugging is disabled.
Views
User view
Default command level
1: Monitor level
Examples
# Enable link aggregation event debugging. Output similar to the following example is generated when
you remove aggregation group 10 which contains a member port Ethernet 1/1.
<Sysname> debugging link-aggregation event
*Nov 3 19:09:58:94 2007 Sysname LAGG/7/LAGG_DEBUG:
EVENT.303.0-15184070: Set port Ethernet1/1 block/unblock successfully
// Ethernet 1/1 was set to block/unblock state successfully.
*Nov 3 19:09:58:94 2007 Sysname LAGG/7/LAGG_DEBUG:
EVENT.304.0-15184070: Modify group 10 to driver successfully
// The modification of group 10 was issued to the driver successfully.
debugging link-aggregation lacp fsm
Use debugging link-aggregation lacp fsm to enable debugging for LACP state machines.
Use undo debugging link-aggregation lacp fsm to disable debugging for LACP state machines.
Syntax
debugging link-aggregation lacp fsm { { actorchurn | mux | partnerchurn | ptx | rx } * | all }
[ interface-list ]
undo debugging link-aggregation lacp fsm { { actorchurn | mux | partnerchurn | ptx | rx } * | all }
[ interface-list ]
Default
Debugging for LACP state machines is disabled on ports.
5