HP Comware 5 Debug Manual Vol 2

IP accounting debugging commands
The IP accounting module name is identified as "IPA" in debugging messages.
debugging ip count
Use debugging ip count to enable IP accounting debugging.
Use undo debugging ip count to disable IP accounting debugging.
Syntax
debugging ip count { all | dada | error }
undo debugging ip count { all | dada | error }
Default
IP accounting debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies all types of IP accounting debugging.
data: Specifies IP accounting data debugging.
error: Specifies IP accounting error debugging.
Usage guidelines
Table 1 describes output fields and messages for the debugging ip count error command.
Table 100 Output from the debugging ip count error command
Field
Command
Failed to get ipa control block pointer
The device failed to obtain IP accounting state on the
receiving or sending interface.
Examples
Figure 1 Network diagram
# Enable IP accounting globally on Router B, and configure the forwarding interfaces to collect IP
accounting statistics in the inbound and outbound direction.
<Sysname> system-view
Router A
Router B
Router C
Eth1/
0
13.13.13
.40/24
Eth1
/0
13
.13.13.46/24
Eth1/1
33.33.33.46/24
Eth1/0
33.33.33.41/
24
119