HP Comware 5 Debug Manual Vol 2

Examples
# Configure an ACL.
<Sysname> system-view
[Sysname] acl number 3050
[Sysname-acl-adv-3050] rule permit ip source 10.1.1.0 0.0.0.255 destination 10.1.1.0
0.0.0.255
[Sysname-acl-adv-3050] quit
[Sysname] quit
# Enable IP packet debugging.
<Sysname> terminal debugging
<Sysname> debugging ip packet acl 3050
# Ping 10 .1.1. 2.
<Sysname> ping –c 1 10.1.1.2
Output similar to the following example is generated:
PING 10.1.1.2: 56 data bytes, press CTRL_C to break
*Aug 3 05:12:33:619 2006 Sysname IPFWD/7/debug_case:
Sending, interface = Ethernet1/1, version = 4, headlen = 20, tos = 0,
pktlen = 84, pktid = 36756, offset = 0, ttl = 255, protocol = 1,
checksum = 5648, s = 10.1.1.1, d = 10.1.1.2
prompt: Sending the packet from local at Ethernet1/1
// IP forwarding sent a packet out of local interface Ethernet 1/1.
*Aug 3 05:12:33:621 2006 Sysname IPFWD/7/debug_case:
Receiving, interface = Ethernet1/1, version = 4, headlen = 20, tos = 0,
pktlen = 84, pktid = 7751, offset = 0, ttl = 255, protocol = 1,
checksum = 34653, s = 10.1.1.2, d = 10.1.1.1
prompt: Receiving IP packet from Ethernet1/1
// IP forwarding received an IP packet from local interface Ethernet 1/1.
*Aug 3 05:12:33:622 2006 Sysname IPDBG/7/debug_case:
Delivering, interface = Ethernet1/1, version = 4, headlen = 20, tos = 0,
pktlen = 84, pktid = 7751, offset = 0, ttl = 255, protocol = 1,
checksum = 34653, s = 10.1.1.2, d = 10.1.1.1
prompt: IP packet is delivering up!
// IP forwarding delivered a received packet to the upper layer.
Reply from 10.1.1.2: bytes=56 Sequence=1 ttl=255 time=5 ms
--- 10.1.1.2 ping statistics ---
1 packet(s) transmitted
1 packet(s) received
0.00% packet loss
round-trip min/avg/max = 5/5/5 ms
debugging ip virtual-reassembly
Use debugging ip virtual-reassembly to enable IP virtual fragment reassembly (VFR) debugging.
Use undo debugging ip virtual-reassembly to disable IP virtual fragment reassembly debugging.
123