HP Comware 5 Debug Manual Vol 2

Syntax
debugging link-aggregation lacp packet { all | { receive | send } * } [ interface-list ]
undo debugging link-aggregation lacp packet { all | { receive | send } * } [ interface-list ]
Default
LACPDU debugging is disabled on ports.
Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies debugging for sent and received LACPDU.
send: Specifies debugging for sent LACPDUs.
receive: Specifies debugging for received LACPDUs.
interface-list: Specifies an interface range in the form of interface-type interface-number [ to
interface-type interface-number ], where interface-type specifies the interface type and interface-number
specifies the interface number.
Usage guidelines
If no port is specified, this command applies to all ports running LACP.
Table 2 describes output fields and messages for the debugging link-aggregation lacp packet
command.
Table 3 Output from the debugging link-aggregation lacp packet command
Field
Description
size LACPDU size in bytes.
subtype Protocol sub-type of packets. This field is 1 for LACPDUs.
version Protocol version information. Version 1 represents the LACP protocol.
Actor Local port information carried in the LACPDUs:
• type valued 1—Local port information.
• len—Information length.
• sys-pri—LACP system priority of the local end (the actor)
• sys-mac—System MAC address of the actor.
• key—Operational key of the local port.
• pri—LACP priority of the local port.
• port-index—Local port number.
• state—Current LACP state flag of the local port.
9