HP Comware 5 Debug Manual Vol 2

Protect Flow:
Peer IP :15.1.1.2 Mask :255.255.255.0
Source IP :14.1.1.2 Mask : 255.255.255.0
Protocol Number :0
// The IPsec module created an inbound IPsec SA. The IPsec SA has the following details:
 Security protocol is ESP.
 Authentication algorithm is MD5.
 Encryption algorithm is DES.
*Jun 28 19:32:44:252 2006 Sysname DPIPSEC/7/debug:
IPsec Command Operation :Create IPsec SA.
SA Protocol : ESP
Authentication arithmatic : HMAC-MD5-96
Encryption arithmatic : DES
IPsec SA ID :1591
Interface Index :1048579
Control Block ID :1045
ACL Rule Number :0
SPI :785556908
Replay Windows Size :32
Authentication Key Length :16
Authentication Key :4bd756e313cd65986efecb5f95a00075
Encryption Key Length :8
Encryption Key :7889d365f0e5b5a1
SA Hard expire Bytes :262144
SA Soft Expire Bytes :235926
Peer IP :11.1.1.2
Sourc IP :12.1.1.2
Protect Flow:
Peer IP :15.1.1.2 Mask :255.255.255.0
Source IP :14.1.1.2 Mask :255.255.255.0
Protocol Number :0
// The IPsec module created an outbound IPsec SA, which uses the security protocol of ESP, the
authentication algorithm of MD5, and the encryption algorithm of DES.
[Sysname]interface gigabitethernet 1/3
[Sysname-GigabitEthernet1/3] ipsec policy map
[Sysname-GigabitEthernet1/3]
*Jun 28 20:44:44:313 2006 Sysname IPSEC/7/DBG:Notify DP: create ipsec policy control
block.
*Jun 28 20:44:44:313 2006 Sysname IPSEC/7/DBG:The process result of DP: success.
*Jun 28 20:44:44:313 2006 Sysname DPIPSEC/7/debug:
IPsec Command Operation :Create Driver Control Block.
Control Block ID :3
SA Mode :ISAKMP
Control Block ISAKMP Sequence :1
ACL Number :3000
Protect Mode :per rule.
Interface Index :0x100003
150