HP Comware 5 Debug Manual Vol 2

*Jan 11 08:41:54:917 2012 Sysname DPIPSEC/7/debug:IPsec_Packet: thread 15, esp
authentication succeed.
// The output is the IPsec processing information on the responder after the IPsec SA negotiation
succeeded.
•
On a firewall device with multi-core CPUs
# Enable IPsec stateful failover debugging. When the device operates in IPsec stateful failover
mode, output similar to the following example is generated:
<Sysname> debugging ipsec synchronization
IPSEC_REDUN: Got IPsec TDB redundancy info:
SPI 123456789, Anti-Replay 12345,
Current byte life 1234567890123.
// The IPsec module received IPsec TDB redundancy information, showing that the device was
synchronizing IPsec service data.
IPSEC_REDUN: Got IPsec TDB redundancy info:,
SPI 987654321, Anti-Replay 12345,
Current byte life 102411.
// The IPsec module received IPsec TDB redundancy information, showing that the device was
synchronizing IPsec service data.
debugging encrypt-card
Use debugging encrypt-card to enable encryption card debugging.
Use undo debugging encrypt-card to disable encryption card debugging.
Syntax
debugging encrypt-card { all | error | packet | sa }
undo debugging encrypt-card { all | error | packet | sa }
Default
Encryption card debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies all types of encryption card debugging.
error: Specifies encryption card error debugging.
packet: Specifies encryption card packet debugging.
sa: Specifies encryption card SA debugging.
Usage guidelines
Table 7 describes output fields and messages for the debugging encrypt-card all command.
152