HP Comware 5 Debug Manual Vol 2

undo debugging ike { all | dpd | error | exchange | message | synchronization }
Default
IKE debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies all types of IKE debugging.
dpd: Specifies Dead peer detection (DPD) debugging.
error: Specifies IKE error debugging.
exchange: Specifies IKE exchange mode debugging.
message: Specifies IKE message debugging.
synchronization: Specifies IKE stateful failover debugging.
Usage guidelines
Table 8 describes output fields and messages for the debugging ike dpd command.
Table 119 Output from the debugging ike dpd command
Field
Description
send VID
The IKE module sent the vendor ID (for example, the ID
of a vendor that supports DPD).
vendor[0]
Array for storing vendor information (for example, ID
information).
Table 9 describes output fields and messages for the debugging ike exchange command.
Table 120 Output from the debugging ike exchange command
Field
Description
Connection name
Connection name, including the source address,
destination address, policy, and priority.
exchange lookup by name
Exchange by name (including the source address,
destination address, policy, and priority).
exchange create(i) The initiator created an exchange.
exchange create(r) The responder created an exchange.
exchange validate
The IKE module was validating the exchange in phase
1.
exchange run(i) The initiator was sending the exchange.
exchange run(r) The responder was sending the exchange.
exchange lookup from cookie
The IKE module was performing exchange lookup
based on the cookie of the initiator.
154