HP Comware 5 Debug Manual Vol 2

Table 4 Output from the debugging oam critical-event command
a. Field
b. Description
c.
OAM Port XXX: XXX
occurs
d.
A critical link event occurred on an
Ethernet OAM-enabled interface.
Table 2 describes output fields and messages for the debugging oam error command.
Table 5 Output from the debugging oam error command
a. Field
b. Description
c.
OAM Port XXX: XXX
d.
Errors occurred on an Ethernet
OAM-enabled interface.
Table 3 describes output fields and messages for the debugging oam fsm command.
Table 6 Output from the debugging oam fsm command
a. Field
b. Description
c.
OAM Port XXX:
Discovery state
transfers from state XX
to state XXX
d.
The Discovery state machine of an
Ethernet OAM interface transited from
one state to another state.
Table 4 describes output fields and messages for the debugging oam link-event command.
Table 7 Output from the debugging oam link-event command
a. Field
b. Description
c.
OAM Port XXX: XXX
occurs
d.
An Ethernet OAM link event occurred on
an Ethernet OAM-enabled interface.
Table 5 describes output fields and messages for the debugging oam packet command.
Table 8 Output from the debugging oam packet command
a. Field
b. Description
c.
Send/Receive OAM Packet Via
Port XXX
d.
An Ethernet OAM packet was
sent or received on a specific
interface.
e.
Pkt length
f.
Packet length.
Examples
# Enable debugging for Ethernet OAM critical link events on Ethernet 1/1. The output in this example
was created when the following conditions exist:
•
Enable Ethernet OAM on a full-duplex fiber interface.
•
Remove the Rx end of the optical fiber from the interface.
<Sysname> debugging oam critical-event interface ethernet 1/1
*0.10030698 Sysname ETHOAM/8/LinkFault:
OAM Port Ethernet1/1:Link Fault Event occurs.
// A Link Fault event occurred on Ethernet 1/1.
12