HP Comware 5 Debug Manual Vol 2

IPv6 MBGP debugging commands
debugging bgp update ipv6 multicast
Use debugging bgp update ipv6 multicast to enable BGP update debugging for IPv6-MBGP address
family.
Use the undo debugging bgp update ipv6 command to disable BGP update debugging for IPv6-MBGP
address family.
Syntax
debugging bgp update ipv6 multicast [ peer { ip-address | group-name } ] [ receive | send ] [ verbose ]
undo debugging bgp update ipv6 multicast [ peer { ip-address | group-name } ] [ receive | send ]
[ verbose ]
Default
BGP update debugging for IPv6-MBGP address family is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
ip-address: Specifies the IP address of the peer entity.
group-name: Specifies the peer group, which is a string of 1 to 47 characters.
receive: Specifies debugging for received BGP updates.
send: Specifies debugging for sent BGP updates.
verbose: Displays detailed debugging information.
Usage guidelines
Enabling debugging might affect system performance. Therefore, use this command only when
necessary and disable debugging once the debugging operation is complete.
Table 1 describes the output fields and messages for the debugging bgp update ipv6 multicast
command.
Table 127 Output from the debugging bgp update ipv6 multicast command
Field
Description
BGP.xxx Name of the current instance.
Recv UPDATE from x.x.x.x BGP received an update from BGP neighbor x.x.x.x.
Recv UPDATE(Withdraw) from x.x.x.x
BGP received an update withdraw from BGP
neighbor x.x.x.x.
Error identified while receiving UPDATE message from
the peer x.x.x.x and ignored
Error was found in the received update message from
neighbor x.x.x.x, and the message was ignored.
197