HP Comware 5 Debug Manual Vol 2

EtoPPP and EtoFR debugging commands
The EtoPPP and EtoFR module name is identified as "ETOTDM" in debugging messages.
The output description tables in this document only contain fields and messages that require an
explanation.
EtoPPP debugging commands
debugging etoppp
Use debugging etoppp to enable a type of EtoPPP debugging on the specified interface or globally if no
interface is specified.
Use undo debugging etoppp to disable a type of EtoPPP debugging on the specified interface or globally
if no interface is specified.
Syntax
debugging etoppp { all | error | event | packet } [ interface interface-type interface-number ]
undo debugging etoppp { all | error | event | packet } [ interface interface-type interface-number ]
Default
EtoPPP debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: Enables all types of EtoPPP debugging.
error: Enables EtoPPP error debugging.
event: Enables EtoPPP event debugging.
packet: Enables EtoPPP packet debugging.
interface-type interface-number: Specifies an interface by its type and number, for which debugging
information is to be output. The interface can only be a Layer 3 Ethernet interface, Ethernet subinterface,
or VLAN interface. It cannot be a VE interface.
Usage guidelines
Table 1 describes output fields and messages for the debugging etoppp packet command.
Table 9 Output from the debugging etoppp packet command
Field
Description
Receive a ip packet, interface : [string] An IP packet was received on the displayed interface.
15