HP Comware 5 Debug Manual Vol 2

Syntax
debugging mrm ipv6 { all | event | packet [ advanced-acl6-number ] | route [ advanced-acl6-number ] }
undo debugging mrm ipv6 { all | event | packet | route }
Default
IPv6 MRM debugging is disabled.
Views
User view
Default command level
2: System level
Parameters
all: Specifies all types of debugging for IPv6 multicast routing management (MRM).
event: Specifies IPv6 MRM event debugging.
packet: Specifies debugging for IPv6 MRM packets.
route: Specifies IPv6 MRM route debugging.
advanced-acl6-number: Specifies an advanced IPv6 ACL number in the range of 3000 to 3999.
Usage guidelines
Table 10 describes output fields and messages for the IPv6 MRM debugging commands.
Table 137 Output from the debugging mrm ipv6 event command
Field
Description
(sadd, gadd) (S, G) entry.
Failed Operation failed.
T a b l e 11 describes output fields and messages for the debugging mrm ipv6 packet command.
Table 138 Output from the debugging mrm ipv6 packet command
Field
Description
Received Received IPv6 packets.
MFIB information(NOCACHE)
MFIB information(WRONGIF)
MFIB information(ACTIVE)
MFIB information(INACTIVE)
MFIB information(SPT)
MFIB information(CLEAR)
MFIB information(REG-Timeout)
Pim
Types of received IPv6 packets:
• MFIB information(NOCACHE)
• MFIB information(WRONGIF)
• MFIB information(ACTIVE)
• MFIB information(INACTIVE)
• MFIB information(SPT)
• MFIB information(CLEAR)
• MFIB information(REG-Timeout)
• Pim
(sadd, gadd) (S, G) entry.
Tab l e 12 describes output fields and messages for the debugging mrm ipv6 route command.
208