HP Comware 5 Debug Manual Vol 2

// IPv6 NetStream was sending a packet.
*Mar 21 12:53:37:765 2008 H3C NS6/7/NS6_EVENT:
Succeed in sending (Now queue length is 0):
Packet Type: Aggre as Version No: 0 Records: 1
// A packet was successfully sent.
*Mar 21 12:53:37:765 2008 H3C NS6/7/NS6_EVENT:
CPU 0 as Aggre Export 1 packets for timeout
// An AS aggregation packet was sent.
debugging ipv6 netstream packet
Use debugging ipv6 netstream packet to enable IPv6 NetStream packet debugging.
Use undo debugging ipv6 netstream packet to disable IPv6 NetStream packet debugging.
Syntax
debugging ipv6 netstream packet
undo debugging ipv6 netstream packet
Default
IPv6 NetStream packet debugging is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Table 2 describes the output fields and messages for the debugging ipv6 netstream packet command.
Table 141 Output from the debugging ipv6 netstream packet command
Field
Description
Send succeed! IPv6 NetStream sent a packet successfully.
Send fail! IPv6 NetStream failed to send a packet.
Packet Type: Normal IPv6 Version No: 0 Records: 1
SrcIP(Port): 192.168.20.173(40000) DstIP(Port):
192.168.20.180(138) VrfID: 0
• Packet Type—Exported packet type.
• Version No—Exported packet version.
• Records—Number of packets exported.
• SrcIP(Port)—Source IP address (source port).
• DstIP(Port)—Destination IP address (destination
port).
• VrfID—Private network route index.
Examples
# Enable IPv6 NetStream packet debugging. The output similar to the following example is generated
when an IP packet arrives at Ethernet 1/0 and an entry ages out under the following conditions:
•
IPv6 NetStream is enabled on Ethernet 1/0.
•
A destination host is configured.
216