HP Comware 5 Debug Manual Vol 2

# Enable EtoPPP event debugging. Output similar to the following example is generated when an EtoPPP
translation entry is created to map Ethernet 1/1 to PPP-enabled Serial 2/0
<Sysname> debugging etoppp packet interface ethernet1/1
*Mar 7 18:04:09:548 2008 MSR49 ETOTDM/7/etotdm_event:
(Ethernet1/1)ETOFR/EVT: Response of adding a entry !
*Mar 7 18:08:59:803 2008 MSR49 ETOTDM/7/etotdm_event:
(Ethernet1/1)ETOFR/EVT: Response of deleting a entry !
NOTE:
The debugging output for EtoPPP packet debugging only covers IP and ARP packets.
EtoFR debugging commands
debugging etofr
Use debugging etofr to enable a type of EtoFR debugging for the specified interface or globally if no
interface is specified.
Use undo debugging etofr to disable a type of EtoFR debugging for the specified interface or globally
if no interface is specified.
Syntax
debugging etofr { all | error | event | packet } [ interface interface-type interface-number ]
undo debugging etofr { all | error | event | packet } [ interface interface-type interface-number ]
Default
EtoPPP debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: Enables all types of EtoFR debugging.
error: Enables EtoFR error debugging.
event: Enables EtoFR event debugging.
packet: Enables EtoFR packet debugging.
interface-type interface-number: Specifies an interface by its type and number, for which debugging
information is to be output. The interface can only be a Layer 3 Ethernet interface, Ethernet subinterface,
or VLAN interface. It cannot be a VE interface.
Usage guidelines
Table 4 describes output fields and messages for the debugging etofr packet command.
17