HP Comware 5 Debug Manual Vol 2

Field
Description
no BSR is available No BSR is available.
add/remove register vif A register virtual interface was added or removed.
Expiring CRP
C-RP that aged out.
Lose the ASBSR election
The device lost the BSR election in the BSR
admin-scope region.
Lose the BSR election
The device lost the BSR election.
locally scoped
Node-local or link-local scope.
RP changed The RP has changed.
pending state The BSR changed to the pending state.
Update the BSR's state to elected The BSR changed to the elected state.
RPF Failure RPF check failed.
admin scope multicast address
Address in the admin-scope range.
Table 9 describes output fields and messages for the debugging pim ipv6 state-refresh command.
Table 150 Output from the debugging pim ipv6 state-refresh command
Field
Description
SRM
State refresh message.
Message truncated
Message length is invalid.
bad group address Incorrect IPv6 group address.
Invalid group mask length
Incorrect group address prefix length.
Originator address
Address of the state refresh message originator.
preference
Preference field of the message.
metric
Metric field of the message.
mask length
Prefix length field of the message.
ttl
TTL value of the message.
prune indicator
Prune indicator flag bit.
prune now
Prune now indicator flag bit.
assert override
Assert override flag bit.
Examples
The output in the following examples was created under the condition that IPv6 PIM-DM or IPv6 PIM-SM
is enabled:
# Enable debugging for inbound IPv6 PIM assert messages.
<Sysname> debugging pim ipv6 assert receive
*0.7453954 Sysname PIM/7/ASSERT:IPv6:(public net): PIM ver 2 AST receiving
FE80::2E0:FCFF:FE02:1A01 -> FF02::D on Vlan-interface20 (P012343)
*0.7453954 Sysname PIM/7/ASSERT:IPv6:(public net): For FF0E::101:101/128 from
100:100::168, rpt unset, pref 0, metric 0 (P012351)
225