HP Comware 5 Debug Manual Vol 2

Table 12 Output from the debugging etofr packet command
Field
Description
Receive a ip packet, interface : [string] An IP packet was received on the displayed interface.
Receive a arp packet, interface : [string], opertype:
[string], Src IP: [string], Des IP: [string]
An ARP packet was received on the displayed
interface. The operation code for the packet and the
source and destination IP addresses of the packet are
displayed.
Send a ip packet, interface : [string] An IP packet was sent out the displayed interface.
Send a arp packet, interface : [string], opertype:
[string], Src IP: [string], Des IP: [string]
An ARP packet was sent out the displayed interface.
The operation code for the packet and the source and
destination IP addresses of the packet are displayed.
Send a inarp packet, interface : [string], opertype:
[string], Src IP: [string], Des IP: [string]
An InARP packet was sent out the displayed interface.
The operation code for the packet and the source and
destination IP addresses of the packet are displayed.
Discard a packet, interface : [string], reason: [string] An IP packet was dropped on the displayed interface
for the displayed reason.
Table 5 describes output fields and messages for the debugging etofr event command.
Table 13 Output from the debugging etofr event command
Field
Description
EtoFR EVT: Interface : [string], [string] An EtoFR event occurred on the displayed interface.
This event could be one of the following types:
• The interface was removed due to hot swapping.
• The Ethernet interface went up or down.
• The Ethernet subinterface was shut down or
brought up (due to the undo shutdown command).
• The VLAN ID of the Ethernet subinterface was
added, modified, or removed.
• The state of the PVC changed.
• A translation entry was added, removed, or
updated.
Table 6 describes output fields and messages for the debugging etofr error command.
Table 14 Output from the debugging etofr error command
Field
Description
EtoFR ERR :Interface : [string], [string] An EtoFR error occurred on the displayed interface.
This message is used to describe EtoFR processing
errors, such as a translation entry adding/removal
failure.
Examples
# Enable EtoFR packet debugging. Output similar to the following example is generated when an EtoFR
translation entry is created to map Ethernet 1/1 to FR-enabled interface Serial 2/0.
<Sysname> debugging etofr packet interface ethernet1/1
*Mar 10 18:41:39:742 2008 Router ETOTDM/7/etotdm_rcv_ip:Receive a ip packet, interface :
Serial2/0
18