HP Comware 5 Debug Manual Vol 2

debugging ipx rtpro-flush
Use debugging ipx rtpro-flush to enable IPX routing flush debugging.
Use undo debugging ipx rtpro-flush to disable IPX routing flush debugging.
Syntax
debugging ipx rtpro-flush
undo debugging ipx rtpro-flush
Default
IPX routing flush debugging is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Table 5 describes output fields and messages for the debugging ipx rtpro-flush command.
Table 156 Output from the debugging ipx rtpro-flush command
Field
Description
IPXRM set a Rth on the flash list, ulRthDest =
destination-network
A route is added to the flash list.
IPXRM finish a flash, reset a Rth on the flash list,
ulRthDest = destination-network
The flash list is updated when route flush completes.
Examples
# Enable IPX routing flush debugging. When a static route is configured, output similar to the following
example is generated:
<Sysname> debugging ipx rtpro-flush
<Sysname> system-view
[Sysname] ipx route-static 100 1.0000-5e01-180a
*Jul 24 15:08:57:141 2006 Sysname RMX/7/DBG:
IPXRM set a Rth on the flash list, ulRthDest = 0x100.
// IPXRM added a route to the flash table.
debugging ipx rtpro-interface
Use debugging ipx rtpro-interface to enable interface change debugging for IPX routing.
Use undo debugging ipx rtpro-interface to disable interface change debugging for IPX routing.
Syntax
debugging ipx rtpro-interface
undo debugging ipx rtpro-interface
243