HP Comware 5 Debug Manual Vol 2

Interface name is Ethernet1/1 .
// IPXRM received a message that the IPX protocol is down on Ethernet 1/1.
[Sysname-Ethernet1/1] undo shutdown
%Jul 24 15:33:17:297 2006 Sysname IFNET/4/UPDOWN:
Line protocol on the interface Ethernet1/1 is UP
%Jul 24 15:33:17:297 2006 Sysname IFNET/4/UPDOWN:
Protocol IPX on the interface Ethernet1/1 is UP
*Jul 24 15:33:17:297 2006 Sysname RMX/7/DBG:
IPXRM receive interface change msg, msg type IPX_IF_UP .
if_index is 0xf0018 .
Interface name is Ethernet1/1 .
// IPXRM received a message that the IPX protocol is up on Ethernet 1/1.
debugging ipx rtpro-routing
Use debugging ipx rtpro-routing to enable IPX routing change debugging.
Use undo debugging ipx rtpro-routing to disable IPX routing change debugging.
Syntax
debugging ipx rtpro-routing
undo debugging ipx rtpro-routing
Default
IPX routing change debugging is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Table 7 describes output fields and messages for the debugging ipx rtpro-routing command.
Table 158 Output from the debugging ipx rtpro-routing command
Field
Description
Dest: destination-network Nexthop:
nexthop-network.nexthop-node
Interface: exit-interfac -network.exit-interfac
-node(interface-name)
Protocol: protocol Preference: preference
Ticks: ticks Hops: hops
Information about the change in IPX routing:
• nexthop-network—IPX network number of the next
hop address.
• nexthop-node—IPX node number of the next hop
address.
• exit-interface-network—IPX network number of the
outbound interface address.
• exit-interface-node—IPX node number of the
outbound interface address.
• protocol—IPX routing protocol number.
• preference—IPX routing preference.
• ticks—Time delay of a route in ticks.
245