HP Comware 5 Debug Manual Vol 2

IRF debugging commands
IRF is managed by the stack topology management (STM) module.
The output description tables in this document only contain fields and messages that require an
explanation.
debugging stm all
Use debugging stm all to enable all types of IRF debugging.
Use undo debugging stm all to disable all types of IRF debugging.
Syntax
debugging stm all [ chassis chassis-number slot slot-number ]
undo debugging stm all [ chassis chassis-number slot slot-number ]
Default
All types of IRF debugging are disabled.
Views
User view
Default command level
1: Monitor level
Parameters
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The chassis-number
argument represents the IRF member ID. The slot-number argument represents the slot number of the card.
Examples
# Enable all types of IRF debugging on the active MPU of IRF member dev i c e 1.
<Sysname> debugging stm all chassis 1 slot 0
debugging stm topology
Use debugging stm topology to enable IRF topology collection debugging.
Use undo debugging stm topology to disable IRF topology collection debugging.
Syntax
debugging stm topology { all | error | event | notify | packet | state | timer } [ chassis chassis-number
slot slot-number ]
undo debugging stm topology { all | error | event | packet } [ chassis chassis-number slot slot-number ]
Default
All types of IRF topology collection debugging are disabled.
Views
User view
249