HP Comware 5 Debug Manual Vol 2

Field
Description
Set irf port failed. Ret: ret
Enabling or disabling an IRF port failed because of a
driver interface call failure.
Irf-port is already down. Irf-port: irf port
The IRF port had been down when STM received the
down event message from the driver.
Irf-port is already up. Irf-port: irf port
The IRF port had been up when STM received the up
event message from the driver.
Write queue failed. Message: Irf-port status
STM failed to write to the queue the IRF-port status
message received from the driver.
Set IRF port silence failed. Ret: ret STM failed to set the IRF port to silence.
Process receive hello packet timer out failed. Ret: ret,
Irf-port: irf port
STM failed to process a hello packet receipt timeout
event.
Get the max and min slot ID by ulMemberID failed.
ulRet: ulRet
STM failed to obtain the global minimum slot number
and the global maximum slot number based on the
specified chassis. The result is printed.
Create the view of IRF-port is failed. ulRet: ulRet STM failed to create an IRF port view.
Disable the ulChassisID IRF-port ulStackPortIndex STM failed to disable the IRF port on the chassis.
Get the chassisID by board globalslotID failed. ulRet:
ulRet
STM failed to get the chassis number based on the
global slot number.
Failed to set the stack port because ulGetChassisID
and ulChassisID are different
STM failed to configure the IRF port, because the IRF
port does not belong to the chassis.
Table 2 describes output fields and messages for the debugging stm topology event command.
Table 162 Output from the debugging stm topology event command
Field
Description
irf-port: irf-port
The IRF port that sent or received the hello packet: 1
for IRF-port 1 and 2 for IRF-port 2.
Neighbor can't be irfed. irf-port: ir -port
STM failed to form an IRF fabric because of
connection error.
IRF-port 1 of one member must be connected to
IRF-port 2 of another.
Neighbor can't be irfed because not compatible
Eachother irf-port: irf port
The neighbor connected to the IRF port cannot form an
IRF fabric with the device.
Check the IRF member chassis models for IRF setup
incompatibility.
Ignore this hello packet before urgent packet has
processed. IRF-port: ulStackPort
STM ignored the hello packet received before the
urgent packet was processed.
Ignore the first hello packet until urgent packet has
been processed. IRF-port: ulStackPort
STM ignored the first hello packet received after the
urgent packet was processed.
Discard LCS register packet before STM main task
started
STM discarded LCS register packet because the STM
main task had not been created.
LCM removed and LCS will change to LCM LCM was removed and LCS became the new LCM.
251