HP Comware 5 Debug Manual Vol 2

Default command level
1: Monitor level
Parameters
all: Specifies all types of master election debugging.
b-mac: Specifies master election MAC address debugging. This keyword is reserved for future use.
error: Specifies master election error debugging.
event: Specifies master election event debugging.
packet: Specifies master election packet debugging.
state: Specifies master election state debugging.
timer: Specifies master election timer debugging.
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The chassis-number
argument represents the member ID of the IRF member device. The slot-number argument represents the
slot number of the card. The value range varies by device model.
Usage guidelines
Table 4 describes output fields and messages for the debugging stm election error command.
Table 164 Output from the debugging stm election error command
Field
Description
irf-port: irf port
The IRF port that sent or received the hello packet:
• 1—IRF-p o r t 1.
• 2—IRF-port 2.
Ret: ret Returned result.
Set bridge failed. Ret: ret
STM failed to configure the bridge MAC address of
the IRF.
Function type input is invalid. Type: type
Incorrect value was set for IRF bridge MAC
persistence.
IRF bridge MAC persistence settings for the type field:
• 0—Bridge MAC address of the IRF fabric does not
change after the master leaves.
• 1—Bridge MAC address of the IRF fabric persists
for six minutes after the master leaves.
• 2—Bridge MAC address of the new master
replaces the original one as soon as the old master
leaves.
Set bridge mac failed. Ret: ret STM failed to set the bridge MAC persistence setting.
Table 5 describes output fields and messages for the debugging stm election event command.
Table 165 Output from the debugging stm election event command
Field
Description
Don't process bridge mac change packet in non-slave
status. Status: rolestatus
The MPU did not process the bridge MAC change
packet because it was not in Slave (standby MPU)
state.
253