HP Comware 5 Debug Manual Vol 2

debugging stm election
Use debugging stm election to enable master election debugging.
Use undo debugging stm election to disable master election debugging.
Syntax
debugging stm election { all | event | packet | timer | state } [ slot slot-number ]
undo debugging stm election { all | event | packet | timer | state } [ slot slot-number ]
Default
Master election debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies all types of master election debugging.
event: Specifies master election event debugging.
packet: Specifies master election packet debugging.
timer: Specifies master election timer debugging.
state: Specifies master election state debugging.
slot slot-number: Specifies an IRF member device by its member ID.
Usage guidelines
Table 6 describes output fields and messages for the debugging stm election event command.
Table 175 Output from the debugging stm election event command
Field
Description
Don't process bridge mac change packet in non-slave
status. Status: rolestatus
The device did not process the bridge MAC change
packet because it was not in Slave (subordinate) state.
Function type set is same with local configration. Type:
type
The configured IRF bridge MAC persistence setting
was the same as the existing setting.
IRF bridge MAC persistence settings for the type field:
• 0—Bridge MAC address of the IRF fabric does not
change after the master leaves.
• 1—Bridge MAC address of the IRF fabric persists
for six minutes after the master leaves.
• 2—Bridge MAC address of the new master
replaces the original one as soon as the old master
leaves.
Table 7 describes output fields and messages for the debugging stm election packet command.
262