HP Comware 5 Debug Manual Vol 2

Table 4 describes output fields and messages for the debugging isis circuit-information command.
Table 185 Output from the debugging isis circuit-information command
Field
Description
circuitName not enabled for Ipv4
IPv4 is not enabled on the interface.
circuitName indicates the interface name.
circuitName not enabled for Ipv6
IPv6 is not enabled on the interface.
circuitName indicates the interface name.
circuitName not enabled
IS-IS is not enabled on the interface.
circuitName indicates the interface name.
Interface MTU should not be too small(< 131) Interface MTU cannot be smaller than 131.
The IP is set to UP for IS-IS on interface IP of the IS-IS enabled interface is up.
The IP is set to DOWN for IS-IS on interface IP of the IS-IS enabled interface is down.
The IP is set to UP for ISISv6 on interface IP of the IS-ISv6 enabled interface is up.
The IP is set to DOWN for ISISv6 on interface IP of the IS-ISv6 enabled interface is down.
CIRC: Circ Up not processed. Circuit already up
The interface is already up and no more interface up
requests will be processed.
CIRC: Circ Down not processed. Circuit already
Down
The interface is already down and no more interface
down requests will be processed.
CIRC: Join AllIS multicast address error
An error occurred while the interface was joining all
the multicast groups.
CIRC: Join ALLL1IS multicast address error
An error occurred while the interface was joining L1
multicast groups.
CIRC: Join ALLL2IS multicast address error
An error occurred while the interface joined L2
multicast groups.
CIRC: Leave ALLL1IS multicast address error
An error occurred while the interface was leaving L1
multicast groups.
CIRC:Leave ALLL2IS multicast address error
An error occurred while the interface was leaving L2
multicast groups.
CIRC: Leave ALLIS multicast address error
An error occurred while the interface was leaving all
the multicast groups.
CIRC : circuitName not enabled
IS-IS is not enabled on the interface.
circuitName indicates the interface name.
CIRC: Circuit circuitName is on wrong state while
enabling
An error occurred when IS-IS was enabled on the
interface.
circuitName indicates the interface name.
CIRC : circuitName not enabled for Circuit Type
Change
The interface was not enabled with IS-IS when
interface state changed.
circuitName indicates the interface name.
Table 5 describes output fields and messages for the debugging isis datalink-receiving-packet
command.
275